Designation: D − 10Standard Test Method for Energy Measurement for This test method is under the jurisdiction of ASTM Committee D18 on Soil and. Purchase your copy of ASTM D – 16 as a PDF download or hard copy directly from the official BSI Shop. All BSI British Standards available. ASTM D ,. “Standard. Test Method for Stress Wave. Energy Measurement for Dynamic. Penetrometer. Testing. Systems”. , speclfles.
|Published (Last):||13 May 2007|
|PDF File Size:||13.76 Mb|
|ePub File Size:||14.2 Mb|
|Price:||Free* [*Free Regsitration Required]|
The inch-pound units given in parentheses are mathematical conversions which are provided for information purposes only and are not considered standard. Since the measured energy includes the extra potential energy effect due to the set per blow, tests for energy evaluation of the hammer systems should be limited to moderate N-value ranges between 10 asttm 50 Ref 7.
Valid Buy this standard. In this system, the pound lbf represents a unit of force weightwhile the unit for mass is slugs.
ASTM D – 16 – Standard Test Method for Energy Measurement for Dynamic Penetrometers
Alternatively, the N-value can be used directly in foundation design using correlations d463 design parameters such as allowable bearing pressure or pile capacity. Referenced Documents purchase separately The documents listed below are referenced within the subject standard but are not provided as part of the standard.
It is not dd4633 for use with down-hole hammers. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use. In addition, they are representative of the significant digits that generally should be retained.
These notes and footnotes excluding those in tables and adtm shall not be considered as requirements of the standard. The N-value depends on the soil properties but also on the mass, geometry, stroke, anvil, and operating efficiency of the hammer. It is beyond the scope of this standard to consider significant digits used in analytical methods for engineering design. Contact us f4633 Login. Your shopping cart is empty. Shopping cart Close cart 0, foreach: The standard is now in your shopping cart.
Please note that the selected standard f4633 invalid. Read more about SIS Subscriptions. Sustainable Development Goals and standardisation, how do they connect? This procedure may also be applicable to other dynamic penetrometer tests.
In this system, the pound lbf represents a unit of force weightwhile the unit for mass is slugs. Asrm is not intended asttm use with down-hole hammers. The Standard Penetration Test is the most common type. See also Refs 1- 6. The quality of the result produced by this standard is dependent on the competence of the personnel performing it, and the suitability of the equipment and facilities used. What is a standard? Subscribe on standards – Read more. Subscribe on standards with our subscription service.
ASTM D4633 – 16
Link to Active This link will always route to the current Active version of the standard. The procedures used do not consider material variation, purpose for obtaining the data, special purpose studies, or any considerations for the user’s objectives; and it is common practice to increase or reduce significant digits of reported data to be commensurate with these considerations.
Message to your colleague. Reliable results depend on d4633 factors: